3 bottom surface removal – IEI Integration ECW-281B-N270-WT v3.01 User Manual
Page 60

ECW-281B/281B2-R30/N270 Embedded System
Page 45
1
Driver and manual CD
1
One Key Recovery CD
1
Wireless antenna (wireless model only)
1
VESA MIS-D 100 wall mount kit
(optional)
1
DIN mount kit (optional)
Table 4-1: Package List Contents
4.2.3 Bottom Surface Removal
WARNING:
Over-tightening bottom cover screws will cause damage to the bottom
surface. Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
Before the jumper settings can be configured and the hard disk drive can be installed, the
bottom surface must be removed. To remove the bottom surface, please follow the steps
below:
Step 1:
Remove the bottom surface retention screws. The bottom surface is secured to
the chassis with six retention screws (
77
Figure 4-1
). All six screws must be
removed.