IEI Integration IMB-H612A - Manual (Page 71)

IMB-H612 Mic ro -ATX Mo th e rb o a rd
P a g e 56
The USB power select jumpers allow the user to select the USB power setting.
Setting Description
Short 1-2 +5V
Short 2-3 +5V_Dual (Default)
Table 4-4: USB Power Select Jumper Settings
Figure 4-11: USB Power Select Jumpers Location
4.5 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the onboard connectors.
4.5.1 S ATA Drive Co n n e c tio n
The IMB-H612 is shipped with four SATA drive cables. To connect the SATA drives to the
connectors, please follow the steps below.
S te p 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
S te p 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-12.