Warner Electric PCBC-1525_1225 - Manual (Page 4)

4 Warner Electric • 800-825-9050 P-214 • 819-0518
Press the bullet-type connectors firmly into
place. (See Figure 4.)
2. Mount the magnet to the magnet hub using
capscrews and lockwashers. (See Figure 5.)
3. Secure the lead wires to the magnet terminals
with screws and lockwashers.
4. Pull the rubber caps over the terminals
D. Assembling the Brake Armature and
Magnet Hub
Assemble the armature to the magnet hub with the
autogap mounting accessory.
The autogap accessory is a double spring device
which allows for automatic armature clearance and
adjustment for wear. The smaller or conical spring
pushes the armature from the magnet face, leaving
a gap of about 1/32 inch, while the straight spring
automatically follows up for wear. This combination
maintains maximum performance efficiency through-
out the life of the unit.
The assembly procedure for the autogap accessory
is as follows (see Figure 6).
Step 1
Place the straight springs (white) over armature
bosses on the back side of the armature.
(Figure 7)
Short
Wire
Collector
Ring
Terminal
Cap
Long
Wire
Figure 4
Figure 5
Figure 6
Retainer Ring
Heavy
Spring
(Red)
Detent
Spring
Retainer
Detent
Spring
Drive
Pin
Straight
Spring
(White)
Armature
Boss
Armature
Figure 7