Warner Electric Autogap 475 & 650 - Manual

Warner Electric 800-825-9050
Autogap ™ Installation for Sizes 475
& 650 Basic Brakes & Clutches
Installation Instructions
P-1380
819-0111
5181-101-010
Part Number
Failure to follow these instructions
may result in product damage, equipment
damage, and serious or fatal injury to personnel.
Assembly Instructions
Brake or Clutch Coupling Installation
Step 1
Place straight springs over armature bosses on back
side of armature. (Figure 1)
Figure 1
Step 2
Place armature hub over straight springs assembled
in Step 1. (Figure 2)
Straight springs must fit into
grooves in armature hub.
Drive Pin
Conical
Spring
Retainer
Detent
Spring
Straight
Spring Armature
Armature Boss *Armature Hub
* The size 475 armature will differ in appearance from
the one shown, but the assembly procedure is the
same.
Figure 2
Step 3
Compress conical spring against retainer ring by
sliding detent spring towards head of pin. (All 4 pins)
(Figure 3)
Figure 3
Step 4
Insert assembled drive pins through armature hub,
through straight springs and into threaded holes in
back side of armature. Drive pins require application
of Grade “AA” Loctite
® ‚ Sealant on threads. (Figure 4)
Figure 4