Warner Electric Autogap 825-1525 - Manual

Autogap Installation for
Sizes 825-1525 Basic Brakes & Clutches
Installation Instructions
P-1366
819-0016
retainer ring by sliding
detent spring towards
head of pin. (See Figure
2)
Step 3. Insert
assembled drive pins
through segmented side
of armature, through
Assembly Instructions
Step 1. Place straight springs (white) over
armature boss on back side of armature.
(See Figure 1)
(Figure 1)
Step 2. Compress heavy spring (red) against
straight (white) springs and into threaded holes
in armature hub. (See Figure 3)
(Figure 3)
Be sure that straight white springs do not get
caught under shoulder of drive pins.
Step 4. Draw drive pins up tightly until shoulder
Compressed
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.
(Figure 2)
Armature Boss
Straight Spring
(White)
Detent Spring
Retainer
Retainer
Ring
Detent
Spring
Drive Pin
Heavy
Spring
(Red)
Armature
Warner Electric P-1366 • 800-825-9050