Warner Electric Electrically Released Permanent Magnet Clutch Compatible Modules - Manual

Warner Electric 800-825-9050
Electrically Released Permanent Magnet
Clutch Compatible Modules
Installation Instructions
P-1349
819-0318
EM-50-20 FBC 5370-169-056
EM-180-20 FBC 5370-169-057
EM-210-20-FBC 5371-169-028
Warner Electric’s FBC series of Electrically
Released Modules are designed to be used in
clutch-brake combinations only. The FBC
modules can be mounted on a C-face motor
with the proper input module (10 module), and
can also be foot mounted with a 30 Input Clutch
Module and base. The FBC modules include a
spacer for mounting to 10 and 30 clutch
modules. The fail safe brake engages when
power goes off.
10-20 FBC
Reference: Electro-Module Service Manual
P-213.
Mounting Instructions
Follow Steps 1 and 2 in the Service Manual.
Step 3
Assembling two modules. The 20 FBC brake
module may be assembled to the mounted
model 10 motor clutch module as follows:
A. Position the modules with the ventilation
holes down when in their normal horizontal
position to prevent foreign matter from falling
into the units.
B. Assemble the 20 FBC brake module to the
motor clutch module, inserting the spacer
provided between the (20) and (10) modules.
Bolt the modules together with the long hex
head bolts provided.
Follow Steps 4 and 8 in the Service Manual.
20 FBC-30-B
Reference: Electro-Module Service Manual
P-213.
Mounting Instructions
Follow Step 2 in the Service Manual.
Step 3
Assembling two modules. The 20 FBC brake
module may be assembled to the (30) input
clutch module.
A. Position the modules with the ventilation
holes down when in their normal horizontal
position to prevent foreign matter from falling
into the units.
B. Assemble the 20 FBC brake module to the 30
input clutch module, inserting the spacer
provided between the units. Bolt the modules
together with the long hex head bolts provided.
Follow Step 4 in the Service Manual.
Step 7
Installing the Base Mount. The 20 FBC brake
module and the 30 input clutch module can be
base mounted as follows:
A. Mount the modules so that the base is
located below the ventilation holes. A pilot
diameter on the end of each module mates with
pilot diameter on the base.