Teledyne LeCroy WaveSurfer Automation Command - Manual (Page 134)

Automation Command and Query Reference Manual - Control Reference
M3
M4
Z1
Z2
Z3
Z4
RESULT app.Measure.Px.histo.Result
RESULT app.Measure.Px.last.Result
RESULT app.Measure.Px.max.Result
RESULT app.Measure.Px.mean.Result
RESULT app.Measure.Px.min.Result
RESULT app.Measure.Px.num.Result
OPERATOR app.Measure.Px.Operator
This path specifies that the selected ParamEngine or ArithEngine control variables are "here"
RESULT app.Measure.Px.Out.Result
Properties of the type xxxx.Out.Result.yyyy are those of the last completed acquisition. They are not affected if other
cvars are changed after that acquisition was completed. This distinction between "Out.Result" properties and other
cvars is most important when the trigger mode is Single or Stopped. You should treat "Out.Result" properties as read-
only.
1-127
918499 RevA