Print setup – Teledyne LeCroy WaveAce 1000_2000 User Manual
Page 84

WaveAce 1000/2000
78
922131-00 Rev A
1. Press the Screen saver option button to choose from various time
lengths before the oscilloscope display goes blank and enters screen
saver mode. Time length options include 1min , 2min, 5min, 10min,
15min, 30min, 1hour, 2hour, 5hour and Off. Of course, selecting Off
keeps the oscilloscope from entering screen saver mode entirely.
2. Pressing theDate/Time option button shows the Date/Time menu
where you can make this setting and choose to show it on the lower-
right of your display. For more information, see Setting and Displaying
the Date/Time (on page 89).
3. Press the Quick-Cal option button to turn quick calibration On or Off.
4. Press the USB Speed option button to select from Full or High Speed
transfer options for the Back USB connector. See, Back and Side
Connections (on page 8) for more information.
5. Press the Next Page option button to display page 1/4.
Print Setup
NOTE:
As explained in Utility Menu (on page 69), only when the Back USB
option button is set to Printer is the Print Setup... option button
enabled for use.
Your printer may override these setup selections to ensure the best
fit. If selections are not supported by your printer, the oscilloscope uses
the Default setting.
Most USB printers supporting direct printing through Type A USB port
connections are compatible with your WaveAce oscilloscope. Refer to
your printer's product documentation to verify compatibility.