Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 100)

WaveAce 1000/2000
94 922131-00 Rev A
A
USTRALIA
& N
EW
Z
EALAND
D
ECLARATION
O
F
C
ONFORMITY
–
EMC
Oscilloscope complies with the EMC provision of the Radio Communications
Act per the following standards, in accordance with requirements imposed by
Australian Communication and Media Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in
accordance with EN61326-1:2006 and EN61326-2-1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC D
ECLARATION
O
F
C
ONFORMITY
–
L
OW
V
OLTAGE
The oscilloscope meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:

Overvoltage Category II: this refers to equipment intended to be
supplied from the building wiring with a nominal supply voltage up to
300V.

Measurement Category O: this refers to oscilloscope measurement
terminals that are not intended to be directly connected to the MAINS
supply.

Pollution Degree 2: this refers to an operating environment where
normally only dry, non-conductive pollution occurs. Occasionally a
temporary conductivity that is caused by condensation must be
expected. This location is a typical office/home environment.