Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 27)

Operator’s Manual
922131-00 Rev A 21
5. Back USB - Indicates whether the Back USB option is set to Computer or
Printer.

Back USB option set to Computer (as shown previous).

Back USB option set to Printer
6. Horizontal Trigger Position Marker - Shows the horizontal trigger
position.
7. Display Markers (Zero Volts Level) - Show the ground reference points
of the displayed waveforms. If there is no marker, the channel is not
displayed.
8. Display Signal Source
9. Signal Coupling symbol
10. Volts/Division
11. Indicates whether the bandwidth limiting filter is On or Off. The B icon
indicates the filter is On.
12. Main timebase setting (a Window timebase setting is also displayed
when applicable).
13. Trigger Source
14. Frequency Counter of Trigger Signal
15. Trigger type and level indicator
16. Horizontal Trigger Position Readout - Displays the waveform's
horizontal position in time (seconds).
Auto Setup
The Auto Setup function identifies the waveform type and automatically
adjusts controls to produce a usable input signal display.
Four Auto Setup waveform options are available: Multi-Cycle, Single-Cycle,
Rising Edge, and Falling Edge.
Press the AUTO front panel button, and then press the menu option button
adjacent to the desired waveform as follows: