Foredom Series SR - Manual (Page 13)

13
2 Cut the blanks out using a bandsaw or a coping
saw. Cut the top body profile first. Temporarily glue the
side pieces back on the blank using a small drop of hot
glue. This will keep the edges of the blank square when
cutting the side profile. Cut the side profile; then pry the
top and bottom pieces from the body and scrape off
any glue. Cut the side profile for the head. Save the
excess wood.
1 Photocopy the pattern at 100% of its original
size, then trace the side and top body profiles to a
2
1 ⁄
4
” x 6 3 ⁄
4
” x 4” block of butternut or other hard-
wood of your choice. Next, trace the side profile of
the head to a 2
1 ⁄ 2 ” x 3 5 ⁄ 8 ” x 1 5 ⁄ 8 ” block of butternut.
3 Use a soft lead pencil or felt tip pen and
draw a centerline. Also, measure and mark the
center point of the line in the neck area.
4 Drill a hole at the center point measured in
the previous step. Use a 1/8” drill bit and drill a
hole approximately 1
1 ⁄ 4 ” deep.
Rotary Accessory Shaft Dia. Part No.
Typhoon ® Carbide Burs
Cylinder (coarse) 1/4″ KB14522 or
Smooth Top Cylinder (fine) 1/4″ KB14533
Sphere (coarse) 1/4″ KB14395 or
Ball Nose (coarse) 1/4″ KB14716 or
KB14712
Sanding Sleeve (coarse) 1/4″ KB43535-
Change: Substitute Smooth Cut Cylinder KB14544
Sphere (fine) 1/4″ KB14313 or
Ball Nose (fine) 1/8″ KB18715
Flame (fine) 1/8″ KB18915 or
Rotary Accessory Shaft Dia. Part No.
CeramCut Blue ® Stones
Inverted Cone (fine) 1/8″ CK8322 or
Inverted Cone (fine) 3/32″ CK322
Diamond Point
Flame
3/32″ PD22, PD12 or
Smooth Top Cylinder 3/32″ PD15
Sanding Rolls
(coarse, med., fine)
CRL4C, CRLM, CRLF
Split Sanding Mandrel 1/8″ M26 or
Split Sanding Mandrel 3/32″ M23