beautypg.com

Foredom SCH-1 User Manual

Parts list, Foredom, Wiring diagram

background image

5.

On older Switches, all the terminals will be push-in, spring clamp

type. On newer Switches, some terminals have screw fasteners.

To remove wires from the push-in terminals, insert 1.3mm [.05in]

approximate diameter pin or the blade of a jeweler's screwdriver

all the way into the terminal socket to release the spring clamp.

Grasp the tool and wire and pull them together out of the socket.

If you have difficulty removing the wires from the push-in terminals

and you have wire-cutting, stripping, and soldering tools, you can

cut the wires off where they exit from the terminals. To prepare

the cut wires for installation into the replacement Switch, strip

them back exactly 8.25 mm [5/16 in], then apply solder to the

stripped ends to fuse the strands together.

Position wires around adjustment screw post so wires will not

interfere with cover travel.

Snap cover (1) onto hinge posts on top of rear corners of base (3).

Insert adjustment screw (5) through washer (6) and into post

slot and threaded insert in cover (1). Tighten with screwdriver

until cover is just touching the trigger switch pushrod. Do not

tighten the screw further

to avoid pressing the Switch Pushrod

into a permanently "on" position.

7.

6.

8.

Using flat blade of screwdriver inserted at Point A

between Cover (1) and Base (3), carefully pry Cover off.

Remove Trigger Switch (2) from Base mounting bracket.

Unscrew cover adjustment screw (5).

Disconnect Foot Control from Motor and Wall Outlet.

Instructions for Removing
and Replacing Trigger Switch

3.

4.

1.
2.

Connect Wires to New Trigger Switch as shown in the Wiring

Diagram.

Push wires all the way in, so no bare wire is exposed.

On Screw Terminal 1, push wire lead all the way into the socket

then tighten the screw firmly. Push other wire leads all the way

into the designated terminals. Pull on all the wires, making sure

they are secure. Place Switch back into Base mounting bracket.

5

6

1

3

4

2

BLK

GRN

GRN

WHT

BLK

WHT

Female Receptacle

to Motor

Wire Connector

Male Plug to

AC Power Source

Trigger

Switch

Qty

Description

Part No.

Item

1

Cover

CP10852A

1

1

Trigger Switch, 125V

CP10857

2

1

Base

CP10851

3

1

Front Base Pad

CP10859

4

1

Screw, 6−32 x 1"

CP10856

5

1

Washer, #6

CP10862

6

1

Rear Base Pad

CP10860

7

1

Male Cordset

CP10541

8

2

Strain Relief

CP10003−3

9

1

Female Cordset (FCT−1)
Female Cordset (FCH−1)

CP10542
CP10830

10

1

Wire Connector

CP11029

11

Parts List

C.FCT−1 and C.FCH−1
Foot Control, 115V

}

FOREDOM

The Foredom Electric Company

16 Stony Hill Rd., Bethel, CT 06801

203−792−8622

Fax: 203−796−7861

www.foredom.net

Form DN 12/10

Wiring Diagram

1

2

3

4

5

6

7

8

9

10

11

Point A

This manual is related to the following products: