Foredom H.25H User Manual
Foredom, Parts list, Handpiece h.25h
The Foredom Electric Company
Bethel, CT 06801 USA Tel: 203-792-8622
•
Fax: 203-796-7861
www.foredom.net
•
Parts List
Handpiece H.25H
Form 1159A 11/11
Printed in USA
FOREDOM
®
Item Description
Part No.
A
Catch Spring ......................................................HP43
B
Catch Ball ............................................................HP48
C
Sheath Connector ..............................................HP10815
D
Locking Spring....................................................HP10816
E
Ball Lock Sleeve ..................................................HP10817
F
Square Drive Insert ............................................HP10813
G
Wavy Thrust Washer ..........................................HP103103
H
Ball Bearing
(2 required)
........................................HP103121
I
Inner Spacer........................................................HP10447
J
Outer Spacer ......................................................HP10448
K
Baffle Washer ....................................................HP10446
L
Spindle ................................................................HP10812
M
Dust Cap..............................................................HP10445
N
Housing ..............................................................HP10470
O
Collet for
1
⁄
4
″ Shanks ..........................................HP103112
Collet for
3
⁄
16
″ Shanks ........................................HP103113
Collet for
1
⁄
8
″ Shanks ..........................................HP103114
Collet for
3
⁄
32
″ Shanks ........................................HP103115
Collet for
1
⁄
16
″ Shanks ........................................HP103116
Collet for 6mm Shanks ......................................HP103119
Collet for 3mm Shanks ......................................HP103124
Collet for 2.35mm Shanks..................................HP103118
Set of 5 Collets (
1
⁄
16
,
3
⁄
32
,
1
⁄
8
,
3
⁄
16
,
1
⁄
4
) ....................HP103000
P
Chuck Nut ..........................................................HP103105
-
Pin and Wrench ..................................................HP103117
A
C
D
E
F
G
H
H
K
L
M
N
I
J
B
O
P
Instructions for Removing Collet
Loosen chuck nut with the 1/2
″ wrench supplied with the handpiece. If collet is difficult to
remove by hand, insert the shank of a mandrel, grinding stone, bur or other accessory into the
collet. Tap side of accessory lightly with wrench until collet is loosened. Remove collet.
Do not tighten chuck nut down on an empty collet! This may crack or stress the collet, or may
cause the collet to stick in the handpiece.
Do not use undersized or oversized shanks in collet. Always match shank and collet sizes.
Maintenance and Service
1. Do not try to lubricate handpiece. The handpiece is
permanently lubricated and requires no lubrication.
2. Use only a light film of Foredom Flexible Shaft Grease
(P/N 10006) to lubricate the flexible shaft. Run motor for
ten minutes before reconnecting handpiece. Turn off motor,
wipe off any excess grease frm tip of drive shaft and
reconnect handpiece.
3. Return the handpiece to the dealer or directly to the
factory for service.
4. Recommended spare parts to keep on hand:
Set of 5 collets (P/N 103000)
Foredom Flexible Shaft Grease (P/N 10006)