IAI America LSAS-N15HM - Manual (Page 72)

13. Replacement/Adjustment of Stainless Sheet
56
6) Adjust the tension of the stainless sheet.
[1] While looking through the center opening of the clearance check jig, adjust by moving the
stainless sheet on the loose side in the directions of the arrows, so that the clearance between
the top face of the stainless sheet and the back face of the clearance check jig is within the
designated range.
[2] Once the position of the stainless sheet is determined, temporarily tighten the mounting screw on
the loose side so that the stainless sheet will not move.
While looking through the center opening, check the clearance between the top surface of
the stainless sheet and the back surface of the clearance check jig. (As long as the
clearance is within the designated dimension tolerance, there is no problem even if a
difference exists among the entire zone, left and right of the stroke.)
Adjust the tension by moving the stainless
sheet in the directions of the arrows.