IAI America LSAS-N15HM - Manual (Page 66)

13. Replacement/Adjustment of Stainless Sheet
50
13.1.1 Replacement Procedure for Stainless Sheet
1. Replacing the damaged stainless sheet with a new stainless sheet
[1] Check a new stainless sheet to confirm absence of scratches or soiling.
[2] Loosen the screws affixing the damaged stainless sheet and remove the sheet retainer plates.
[3] Connect the damaged stainless sheet and new stainless sheet using adhesive tape.
[4] Slowly pull the end of the damaged stainless sheet so that the sheet slides over the side cover.
* Be careful not to allow the stainless sheet to come off of the side cover and get attracted to the
permanent magnets in the base.
[5] Confirm that the new stainless sheet has been installed in the slider.
Slowly pull out the
sheet.
Connect using adhesive tape.
New stainless sheet
Connect the damaged stainless sheet and new stainless sheet using adhesive tape, and
then slowly pull out the damaged stainless sheet so that the new sheet takes its position.