IAI America LSAS-N15HM - Manual (Page 69)

13. Replacement/Adjustment of Stainless Sheet
53
13.2 N19SS, N19SM
[Required Items]
x Replacement stainless sheet
x Clearance check jig (a regular slider cover with a hole)
(This jig is available at our Sales Engineering Section. Inquire before replacement. It is also available for
purchase.)
x Hex wrench set
x Phillips screwdriver
x Scale
[Notes of Stainless sheet tension]
Improper tension of the stainless sheet can promote deterioration and wear of the sheet.
If the tension of the stainless sheet is too taut and the clearance from the slider cover becomes too
long, it may cause the stainless sheet to undergo fatigue failure.
Conversely, if the tension is too loose, interference will occur between the stainless sheet and the back
face of the slider cover, causing to generate dust.
Therefore, adjust the tension of the stainless sheet using the special adjustment jig, so that the
clearance between the stainless sheet and the back face of the slider cover satisfies the designated
dimensions.
[Name of each part]
Slider cover Stainless sheet
Slider cover mounting flat head screw
Stainless sheet cap screw
Stainless sheet retainer plate