SecurityMan iCamDVR (early 2008 shipment) - Manual (Page 21)

Figure 27 - Record Storage Disk or Partitions
Figure 28 - Internet Configuration
20 | SecurityMan
SuperDVR has the ability to auto detect all the available
HDDs or partitions from within the computer system to
use. More than one HDDs or partitions can be selected as
a storage disk, does not support network drives. To select
storage disk, place check mark on any of the available
drives as shown above. If more than one HDD partitions
are selected the recording will proceed in order from top
to bottom.
Check the “Recycle” option to enable recycle recording.
This means when all the selected HDD partitions are full,
phone audio gain, click on the “Audio Config” button and
setup the microphone gain. The audio gain ranges from 0
to 255 and default setting is 126.
Storage Disk displays all the available disk drives or parti-
tions for the iCamDVR to record all the data files as illus-
trated below:
the recording will continue to overwrite the oldest files
and starts the recycle recording. To disable recycle re-
cording, simply uncheck the “Recycle” option in which the
iCamDVR will stop to record when all the selected HDD
partitions are full.
Internet Config is internet ports in which will need to
be configured in the router for both video and audio to
transmit through to the internet. Settings such as HTTP,
Data, Command, and RPB (Remote Playback) ports which
are required for internet access of iCamDVR. Please refer
to page 51 for more detail on when configuring the ports.