SecurityMan iCamDVR (early 2008 shipment) - Manual (Page 17)

Figure 24 - Record Status Panel and alarm output Status Panel
16 | SecurityMan
Manual Record Mode
Manual Record Mode is the most common record mode
used. This is automatic recording mode where it sustains
the recording until stopped by user.
NoTICe
Higher frame rate can be selected for better picture quality
but requires larger drive space while lower frame rate acquire
less hard drive space but reduces picture quality.
Schedule Record
Schedule record is used to setup time and days of the
week for recording. This mode can be found under the
“Schedule Configuration” panel of Config. When sched-
ule record is active, the green light LED in the Record
Status Panel will light green to show the corresponding
channel is in Schedule Record mode. If the schedule record
mode changes to manual record, the green light LED
will change to teal color LED.
Please refer to “Schedule Configuration” for in depth
details.
Motion Detection Record Mode
Motion detection will enable the system to detect the
changes in the image then activate motion detection,
motion alarm record, and begins to record. For example,
somebody open the door, the system then detects image
changes and begins to record, who opened the door can
be determined when playing back the recorded file. When
there is no movement, the system will not record saving
system resources, hard drive space, and convenient when
searching for event record files. The indicator light color in
the record status panel and Emap will show yellow LED
when motion is detected.