SecurityMan iCamDVR (early 2008 shipment) - Manual (Page 18)

in the alarm Configuration panel to alert when there are
limited amount of space available. Once the present stor-
age space is less than the configured minimum storage
and the recycle record mode is disabled; the recording will
automatically stop.
17 | SecurityMan
To setup Motion Detection Record Mode follows three
easy steps as follow:
Select “Motion Detection”to enable motion detection per
camera under the”basic Configuration”. Each channel
operates independent from one another.
Configure the “Schedule configuration” by setup the
days of the week, the time in a day, and the camera chan-
nel for motion to be active.
Finally, configure the motion detection areas and sensi-
tivity level for each camera(s) in the “Motion_Detection
configuration”
Recycling Record
If Recycling Record function is enabled and all the optional
selected hard disk drives or partitions are full, the oldest
recorded data will be overwritten by the latest/current
recording data.
Storage Disk may vary depending on how many hard
drives or partitions are available in the system. The record-
ing storage disk will automatically advance to the next
partition when full. If all the selected drives/partitions are
full and recycle record mode are enabled, the new record-
ing data will overwrite the former recorded data automati-
cally. HDD minimum storage alarm can also be configured