Fairbanks PC2250 Utility Software - Manual (Page 29)

Section 6: Printers
6/12 29 51214 Rev. 7
Okidata 186 T Form Printer
The FB2250 should be programmed for RS 232, 9600 baud, 8 data bits, and 1 stop
bit. The OUTPUT setting should be “BUTTON” for the Print key.
To change Menu Settings:
1. To enter MENU MODE, press and hold SELECT while turning on the printer. The
“12” and “UTILITY” LEDs will blink.
2. With the printer in the Menu Mode, press SELECT to print the complete menu.
The current default settings print out. It is recommended to use tractor fed paper.
NOTE: The printed menu selections are different for each emulation mode.
3. Press LINE FEED to select the relevant group that needs to be changed (the
group is the left-hand column on the Menu printout).
4. Press FORM FEED to select the relevant item within the selected group (the Item
is the center column on the Menu printout).
5. Press TOF SET to cycle through the settings available for the item you want to
change (the settings are the right-hand column on the Menu printout).
6. To continue making changes: press LINE FEED for the next group or press FORM
FEED for the next item. Repeat as needed until you are finished changing settings.
7. Press PITCH and MODE together to save the changes and exit the Menu Mode.
NOTES:
Exiting the Menu Mode by turning off the printer will cancel any changed settings.
Printed menu’s changes per Printer Emulation Mode. If printer emulation mode is
NOT set to ML, set this first, then reprint the menu. Then set menu as follows: