Fairbanks PC2250 Utility Software - Manual (Page 18)

Section 3: Operation
6/12 18 51214 Rev. 7
Parts Counting and Accumulation
1. Place the Container on the Scale Platform.
2. Press the TARE key to Tare off the container weight and set the scale in the Net
Mode. The Display should indicate 0 Net Weight.
3. Press the B/G NET key. The Display prompts to "Add" a number of sample parts
to the Container. Pressing the B/G NET key repeatedly will Prompt to; "Add 1", "Add
5", "Add 10", "Add 25", Add 50", or "Add 100" parts.
4. Add the required sample to the container, then press the UNITS key. The Display
will alternate between indicating the weight and the Number of pieces.
5. Add the remaining parts to the Container.
6. The Display will update and continue to alternate between the Weight and Number
of Pieces including the original sample.
7. Press the B/G NET key. The Display will alternate between the "Total" legend and
the Total number of pieces accumulated.
Print Example:
Press the B/G NET key to skip adding the Current Piece to the Total Register and
return to the Weigh Mode
Press the UNITS key to complete the Accumulation
Notes:
If the prompts do not occur, clear the accumulator and start over.
The operating mode must be set to Piece Count & total to function.