Teledyne 3010PA - Split architecture percent oxygen analyzer - Manual (Page 4)

iv
Model 3010 Model 3010 Model 3010 Model 3010 Model 3010 PA PA PA PA PA
Specific Model Information
The instrument for which this manual was supplied may incorporate
one or more options not supplied in the standard instrument. Commonly
available options are listed below, with check boxes. Any that are incorpo-
rated in the instrument for which this manual was supplied are indicated by a
check mark in the box.
Instrument Serial Number: __________________________
The instrument with the above serial number has the following
Options:
o 3010PA-C
Three gas inputs, for sample, zero and span gases, with
three solenoid-actuated gas-flow control valves built in.
Valves are automatically synchronized to the analyzer's
electronic control sequences.
o 3010PA–F
Built-in flame arresters for Groups C and D service.
o 3010PA–G
Built-in flame arresters for Groups C and D service, plus
gas-control valves as in –C option, above.
o 3010PA–H
Built-in flame arresters for Group B (hydrogen) service.
o 3010PA–I
Built-in flame arresters for Group B (hydrogen) service,
plus gas-control valves as in –C option, above.
o 3010PA–M 4-20 mA current signal outputs for Percent of Full Scale
and Range ID, in addition to voltage outputs.
o 3010PA–S
Entire sample system including cell block and all wetted
parts fabricated from stainless steel.
o 19" Rack Mount
The 19" Relay Rack Mount units are available with either
one or two series 3000 analyzer Control Units installed in
a standard 19" panel and ready to mount in a standard
rack. See Appendix for details.
o Cell Class*
____________________ (B-1 standard).
Enter Class Designation
* See Part II, Chapter 2 and/or any addendum that may be attached
to this manual for cell specifications.