Teledyne 3010PA - Split architecture percent oxygen analyzer - Manual (Page 24)

Oxygen Analyzer Part I: Control Unit
Part I: 3-3
all the way in with a narrow gauge tool (less than 0.18 inch wide), such as a
small hex wrench or screwdriver Allow clearance for the door to open in a
90-degree arc of radius 7.625 inches. See Figure 3-3.
Figure 3-3: Required Front Door Clearance
3.3 Rear Panel Connections
Figure 3-4 shows the Control Unit rear panel. Connections for power,
communications, and both digital and analog signal outputs are described in
the following paragraphs. Wire size and maximum length data appear in the
Drawings in the back of this manual.
Figure 3-4: Rear Panel of the Model 3010 Control Unit
For safe connections, ensure that no uninsulated wire extends outside of
the connectors they are attached to. Stripped wire ends must insert com-
pletely into terminal blocks. No uninsulated wiring should be able to come in
contact with fingers, tools or clothing during normal operation.