Fulton VMP Webster Oil_Combo Burner - Manual (Page 48)

Page 48 Extended Shutdown / Replacement Parts / Start-Up Report JB Manual
be stocked to support uninterrupted burner operation.
Pilot Electrode
Blower Wheel
Oil Pump (if oil burner)
Oil Pump Coupling (if oil burner)
Pilot Ignition Transformer
Oil Ignition Transformer (if used)
Gas Pilot Solenoid Valve
Flame Scanner
Items with greater life expectancy and/or greater dollar val-
ue, such as flame safety controls, main gas or oil valves and
blower motors should be obtained from your local Webster
representative when a need arises.
L. CARE OF THE BURNER DURING EXTENDED SHUTDOWN
Heating equipment is oftentimes located in an environ-
ment conducive to corrosion and general deterioration if
not properly protected and periodically checked, especially
during an extended period of shut down. The following
procedures should be followed if the burner is going to be
placed out of service even for a short period of time.
1. Turn the main manual fuel valve OFF.
CAUTION
Always keep the main fuel valve(s) OFF if the burner
is shut down for an extended period of time.
2. Turn off the main electrical disconnect to the burner
OFF. Follow tagout / lockout procedures.
M. REPLACEMENT PARTS
3. Place a notification tag or label at the main manual
fuel valve giving reason for shutdown. Follow tagout /
lockout procedures.
4. If the burner is in an area subject to sweating and
condensation, cover the control cabinet and electrical de-
vises with plastic and secure with twine or tape.
5. Should the burner be out of service for more than thirty
(30) days, a complete operational safety check must be
made at the time of restart. The restart must be treated
as a new burner start-up (see burner start-up section in
this manual).
6. The oil nozzle(s), if pressure atomized should be re-
placed. If air atomized, clean the nozzle with cleaning
fluid and a soft brush.
An illustrated parts drawing is included within the Burner
Instructions Manual to aid in parts identification. The noun
name of the part needed should be established from the
drawing, then the part number can be obtained from the
burner material list contained in the Burner Instructions
and Service Manual.
NOTE
Always give Webster Engineering Serial
Number and/or UL Serial Number when
ordering parts.
N. WARRANTY VALIDATION & FIELD START-UP REPORT
As a final step, forward the top copy of the Warranty Valida-
tion and Field Startup Report, Form 113, to:
WEBSTER ENGINEERING & MFG. CO., LLC, 619 Indus-
trial Road, Winfield, KS 67156.
WEBSTER Series JB Burners are listed by Un-
derwriters Laboratories, Inc. (U.L.). Also by the
State of Massachusetts Fire Marshall, City of New
York Board of Standards and Appeals, State of
Minnesota, and can be packaged to meet specific
requirements of CSD-1, GE GAP, IRI, FM, NFPA,
MIL or other special insurance or local code re-
quirements.