Agilent Technologies E8267D PSG - Manual (Page 57)

Chapter 2 43
Basic Operation
Configuring the RF Output
7. The down arrow decreases the frequency by the increment value set in the previous step. Practice
stepping the frequency up and down in 1 MHz increments.
You can also adjust the RF output frequency using the knob. As long as frequency is the active
function (the frequency is displayed in the active entry area), the knob will increase and decrease
the RF output frequency.
8. Use the knob to adjust the frequency back to 700 MHz.
Setting the Frequency Reference and Frequency Offset
The following procedure sets the RF output frequency as a reference frequency to which all other
frequency settings are relative. When the frequency reference is set, the display will read 0.00 Hz
(the frequency output of the signal generator’s hardware minus the reference frequency). Although
the display changes, the actual frequency output is 700 MHz (from step 8 above). Any subsequent
frequency changes are shown as increments or decrements to the 0 Hz reference.
The Frequency Reference Set function is not an active function. Once it is set, any change to the
frequency setting appears as a frequency reading on the signal generator’s front panel display. For
example,
1. Preset the signal generator: Press Preset .
2. Set the frequency reference to 700 MHz:

Press: Frequency > 700 > MHz > More (1 of 3) > Freq Ref Set .
This activates the frequency reference mode, sets the output frequency (700 MHz) as the reference
value, and toggles the
Freq Ref softkey On. The FREQUENCY area displays 0.000 Hz. This reading is
the frequency output of the signal generator’s hardware (700 MHz) minus the reference value
(700 MHz). The signal generator’s true output frequency is 700 MHz. If the
Freq Ref softkey is
toggled to Off, the front panel will indicate the actual frequency: 700 MHz. The REF indicator
appears on the front panel display and the
Freq Ref Off On softkey toggles to On.
3. Turn on the RF output: Press RF On/Off .
The display annunciator changes from RF OFF to RF ON. The RF frequency at the RF OUTPUT
connector is 700 MHz.
4. Set the frequency increment value to 1 MHz: Press Frequency > Incr Set > 1 > MHz .
5. Increment the output frequency by 1 MHz: Press the up arrow key.
The FREQUENCY area display changes to show 1.000 000 000 MHz, which is the frequency output
by the hardware (700 MHz + 1 MHz) minus the reference frequency (700 MHz). The frequency at
the RF OUTPUT changes to 701 MHz.
6. Enter a 1 MHz offset: Press More (1 of 3) > Freq Offset > 1 > MHz .
The FREQUENCY area displays 2.000 000 00 MHz, which is the frequency output by the hardware
(701 MHz) minus the reference frequency (700 MHz) plus the offset (1 MHz). The OFFS indicator
activates. The frequency at the RF OUTPUT connector is still 701 MHz.