Agilent Technologies E8267D PSG - Manual (Page 20)

6 Chapter 1
Signal Generator Overview
Options
• simultaneous modulation configurations (except: FM with
M or Linear AM with
Exponential AM)
• dual function generators that include the following:
— 50–ohm low–frequency output, 0 to 3 Vp, available through the LF output
— selectable waveforms: sine, dual–sine, swept–sine, triangle, positive ramp, negative ramp,
square, uniform noise, Gaussian noise, and dc
— adjustable frequency modulation rates
— selectable triggering in list and step sweep modes: free run (auto), trigger key (single), bus
(remote), and external
Option UNW—narrow pulse modulation
• generate narrow pulses across the operational frequency band of the PSG
• includes all the same functionality as Option UNU
Options
PSG signal generators have hardware, firmware, software, and documentation options. The Data
Sheet shipped with your signal generator provides an overview of available options. For more
information, visit the Agilent PSG web page at http://www.agilent.com/find/psg, select the desired
PSG model, and then click the
Options tab.
Firmware Upgrades
You can upgrade the firmware in your signal generator whenever new firmware is released. New
firmware releases, which can be downloaded from the Agilent website, may contain signal generator
features and functionality not available in previous firmware releases.
To determine the availability of new signal generator firmware, visit the Signal Generator Firmware
Upgrade Center web page at http://www.agilent.com/find/upgradeassistant, or call the number listed
at http://www.agilent.com/find/assist.
To Upgrade Firmware
The following procedure shows you how to download new firmware to your PSG using a LAN
connection and a PC. For information on equipment requirements and alternate methods of
downloading firmware, such as GPIB, refer to the Firmware Upgrade Guide, which can be accessed
at http://www.agilent.com/find/upgradeassistant.
1. Note the IP address of your signal generator. To view the IP address on the PSG, press Utility >
GPIB/RS–232 LAN > LAN Setup .
2. Use an internet browser to visit http://www.agilent.com/find/upgradeassistant.
3. Scroll down to the “Documents and Downloads” table and click the link in the “Latest Firmware
Revision” column for the E8257D/67D or E8663D PSG.
4. In the File Download window, select Run .
5. In the Welcome window, click Next and follow the on–screen instructions. The firmware files
download to the PC.