Agilent Technologies E8267D PSG - Manual (Page 252)

238 Chapter 11
AWGN Waveform Generator
Configuring the AWGN Generator
Generating the Waveform
Press AWGN Off On until On is highlighted.
This generates an AWGN waveform with the parameters defined in the previous procedure. During
waveform generation, the AWGN and I/Q annunciators activate and the AWGN waveform is stored in
volatile ARB memory. The waveform is now modulating the RF carrier.
Real Time I/Q Baseband AWGN
1. Press Preset .
2. Press Mode > More (1 of 2) > AWGN > Real Time I/Q Baseband AWGN
3. Press Bandwidth > 10 > MHz .
Configuring the RF Output
1. Set the RF output frequency to 500 MHz.
2. Set the output amplitude to
10 dBm.
3. Press RF On/Off .
Generating the Waveform
Press AWGN Off On until On is highlighted.
This generates an AWGN waveform with the parameters defined in the previous procedure. During
waveform generation, the AWGN and I/Q annunciators activate. The waveform is now modulating the
RF carrier.