Agilent Technologies Quaternary Pump 1100 Series - Manual (Page 218)

218
Introduction to the Quaternary Pump
Agilent 1100 Series Interfaces
Agilent 1100 Series Interfaces
The Agilent 1100 Series modules provide the following interfaces:
• The CAN connectors serve as the interface between the Agilent 1100
Series modules themselves,
• the GPIB connector serves as the interface between an Agilent1100
module and the Agilent ChemStation,
• RS-232C provides an interface to a computer,
• the APG remote connector serves as the interface between the
Agilent 1100 and other Agilent (APG remote compatible) products,
• the analog output connector(s) provide an analog signal output,
• the interface board slot (not common to all modules) provides specific
interfacing needs (external contacts, BCD, LAN and so on).
For identification and location of the connectors see Figure 3 on page 22.
Table 31 Agilent 1100 Series Interfaces
Interface Type Pumps Autosampler
DA Detector
MW Detector
FL Detector
VW Detector
RI Detector
Thermostatted
Column
Compartment
Vacuum
Degasser
CAN Yes Yes Yes Yes Yes No
GPIB Yes Yes Yes Yes Yes No
RS-232C Yes Yes Yes Yes Yes No
APG Remote Yes Yes Yes Yes Yes Yes
Analog Yes No 2 Ч 1 Ч No
Yes
*
Interface board Yes Yes Yes Yes No No
* The vacuum degasser will have a special connector for specific use. For details, see the degasser manual.