Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 8)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
1.2 Specifications
Item Specification(s)
Power
Range (as specified in model number) 22 - 26 V dc
108 - 132 V rms
216 - 264 V rms
50/60 Hz
Power Consumption (ac/dc operation) 36 VA maximum
Internal Power Supply:
Available Power Output for Transmitters 25 V dc ± 1 V dc @ 80 mA maximum, short circuit protected.
Output Ripple 200 mV p-p maximum
Analog Input (ANI0, ANI1) Signals (all analog in-puts are referenced to signal common)
Quantity 4 (ANI0, ANI1)
Signal Range 0 -5 V dc or 1 -5 V dc (0 -20 mA and 4 -20 mA dc respectively).
 NOTE: The rear terminal board has the appropriate resistors for
ANI0 and ANI1.
Input Impedance 1 megohm minimum for voltage inputs; value of ranging resistor for
current signals.
Measurement Accuracy ± 0.1% of span
Contact Input CCI0 Signal (referenced to power common)
Quantity 1 (CCI0)
Type discrete input
Permitted Contact Resistance 100 ohm maximum
Open/Close Contact Duration for open recognition: 0.05 seconds minimum
for closed recognition: 0.05 seconds minimum
Contact Recognition Level Closed 1 V dc maximum
Contact Recognition Level Open 4 V dc to 24 V dc
Analog Output (ANO0) Signal (referenced to power common)
Quantity 1 (ANO0)
Signal Range 0 -20 mA dc (4 -20 mA dc typically)
Load Range 0 - 750 ohms
Accuracy ± 0.2% of span
Switch Output (CCO0) Signal (referenced to power common)
Quantity 1 (CCO0)
Type solid state switch output
Configuration solid state equivalent of a single pole single throw, normally open or
normally closed contacts referenced to common.
Voltage 30 V dc maximum
Current 50 mA dc maximum
Datalink Communication RS485, four wire, asynchronous; baud rates 300 to 28,800
Sampling and Update Attributes
Program Scan Rate 0.05 seconds
Analog Input Signal Sampling Rate 0.05 seconds
Contact Input Signal Sampling Rate 0.05 seconds
Display Update 0.10 seconds
Output Signal Update 0.05 seconds
Control Ranges
Proportional Band 2 - 1000% and OFF
Integral 0.02 -200 minutes/repeat or Manual Reset from 0-100%
Derivative 0.01 - 8 minutes and OFF
2