Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 71)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
65
8.3 Automatic/Manual Station Parameter Selections
Figure 8-4 illustrates how a Single Loop Controller might appear with only the default values and power
applied, but no analog input or output signals. In Figure 8-4, ANO0 (TB1-lO) is jumpered to ANI0 (TB1-2) to
simulate process operation. The unit has the AC power supply and power cord 173D109U03.
Connecting ANO0 to ANI0 is done only for illustration purposes and is not necessary to configure the
controller. If the controller is connected to a Datalink network, then assign the Instrument Address (8001) and
Baud Rate (8002) first so the remaining datapoints may be entered at the PC.
After this section, refer to Section 9 to configure the parameter display datapoints. The parameter display is
accessed by pressing the F2 push button from this display. All other datapoints not shown in the illustration
are at the default value.
Table 8-2. Analog Input (ANI) Module
Title Symbol
ANI0
Datapoint
ANI1
Datapoint Default
Analog Input (Display Only) ANI H000 H001 0
Engineering Span SPAN C256 C257 100
Engineering Zero ZERO C276 C277 0
Digital Filter Index DFILT B269 B270 3
0-5 V lnput NOBIAS L416 L417 0
Square Root Signal SQRT L440 L441 0
Calibrate Zero CIZ B263 B264
Calibrate Span CIS C296 C297
Tag Name AITAG A224 A225 ANI0 ANI1
Engineering Units AIEU A298 A299 Percent
Table 7-3. Analog Output (ANO) Module
Title Symbol
ANO0
Datapoint Default
Analog Output (Display Only) ANO C000 0
0 - 20 mA Output OZBASE L472 0
Calibrate Zero COZ B267
Calibrate Span COS C300
Tag Name AOTAG 244 ANO0
Table 7-5. Contact Output (CCO) Module
Title Symbol
CCO0
Datapoint Default
Contact Output (Display Only) CCO L024 0
Contact Output Invert OINV L288 0
Tag Name COTAG A280 CCO0