Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 29)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
23
Figure 3-11. Checkerboard Pattern Figure 3-12. Permiter Dots Illuminated
3.5 Defaulting the Database
Defaulting the database sets all non-instrument-specific datapoint parameters to predetermined values, then
suspends the instrument which is indicated by the logo presented on the display. When instrument operation
is suspended, instrument algorithmic control ceases.
The procedure to default the database is presented in Table 3-4 and the display logo is illustrated in Figure 3-
13. Entering a 98 in datapoint B00 defaults the database. If it is desired to suspend instrument operation
without defaulting the database, enter a 00 in lieu of a 98 into B00. The defaulted database values are
provided in the configuration tables of Section 4 and the database tables in Appendix C, Database, under the
column headed Default. Those parameter values that are left unaltered when the database is defaulted are
identified with gray-tone shading in the Default column of the tables. It should be noted that EMODE has a 20
second timeout if it is accessed and its functions (e.g., configure or display) are not used.
Figure 3-13. Display Logo