Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 36)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
Figure 4-1. ANI0-3 Figure 4-2. ANO0
 NOTE: These figures are graphical representations of the signal conditioning that occurs on the
instrument main board. They are provided for reference purposes only.
Table 4-5. Analog Output (ANO) Module
Purpose: The primary purpose of this module is to set the 0 - 20 mA output signal relative to the
displayed percent and to select the analog input signal (ANI0-3) that is to be routed to the analog
output (ANO0).
Title
Symbol ANO0
Datapoint
Default Attribute
Analog Output
(Display Only) ANO0 C000 0 The value in this datapoint represents the
percent of output to be generated by hardware
(e.g., 100% output = 20 mA).
0 -20 mA
Output OZBASE0 L472 0 When a 0, the percentage output generates a 4
-20 mA signal. When set to 1 , the percentage
output generates a 0 -20 mA signal.
Calibrate Zero COZ0 B267
Calibrate
Span
COS0 C300
These parameters are factory set and should
not need adjustment under normal operation.
See Section 5.3 for adjustment.
Tag Name AOTAG0 A244 ANO0 The assignable 10 character name for ANO0.
Table 4-6. Contact Input Module (CCI)
Purpose: This module allows the action of the CCI to be reversed (normally a closed contact = 1, but can be
changed to = 0).
Title Symbol
Datapoint
Default Attribute
Contact
Input
(Display
Only) CCI0 L000 0 When open, a 4 -24 V dc input signal = 0 when IINV = 0.
When open, a 4 -24 V dc input signal = 1 when IINV = 1.
When closed, a < 1 V dc input signal = 1 when IINV = 0.
When closed, a < 1 V dc input signal = 0 when IINV = 1.
Contact
Input
Invert IINV0 L264 0 0 As shown above, it reverses the action of the CCI datapoint.
Tag
Name CITAG A262 CCI0 It is an assignable 10 character name for the contact control input.
30