Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 113)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
107
unications software or 0 when using MicroMod comm
equipment.
CCI Input Invert IINV L264 0 This bit reverses the action of CCI datapoint L000
(Contact Input); therefore, the action of this bit is
explained in datapoint L000.
CCO Output Invert OINV l288 0 This bit reverses the action of CCO datapoint L024
(Contact Output); therefore, the action of this bit is
explained in datapoint L024.
Parameter Display PMD L313 0 ue is 1, the datapoints in this module can
these
is value
ule can be altered by the
Modify Disable
When this val
not be altered with the pushbuttons. The values of
datapoints are only for display purposes. When th
is 0, the datapoints in this mod
operator with the pushbuttons when this module is
displayed.
ANI0 0 - 5 V Input NOBIAS L416 0 cates the input range is Setting this parameter to 1 indi
from 0 - 5 volts (0-20 mA) for ANI0. A 0 indicates the
input range is from 1 - 5 volts (4-20 mA) for ANI0.
ANI1 0 - 5 V Input NOBIAS L417 0 Setting this parameter to 1 indicates the input range is
from 0 - 5 volts (0-20 mA) for ANI1. A 0 indicates the
input range is from 1 - 5 volts (4-20 mA) for ANI1.
ANI0 Square Root SQRT L440 0 t indicates the analog input 0 signal should be
lue.
Signal
When a 0, i
interpreted linearly.
When 1, it indicates the analog input signal should be
interpreted as a square root representation of the va
When square root is selected, input signals less than 1%
(10% input range) force the input to its zero value.
ANI1 Square Root SQRT L441 0 ld be
he analog input signal should be
.
Signal
When a 0, it indicates the analog input 1 signal shou
interpreted linearly.
When 1, it indicates t
interpreted as a square root representation of the value
When square root is selected, input signals less than 1%
(10% input range) force the input to its zero value.
ANO0 0 -20 mA OZBASE L472 0 a 4-
rcentage output of ANO0 generates
Output
When a 0, the percentage output of ANO0 generates
20 mA signal.
When set to 1, the pe
a 0 -20 mA signal.