Micromod Micro-DCI: 53SL5100B Single Loop Controller - Manual (Page 109)

53SL5100B Single-Loop Controller
INSTRUCTION MANUAL
103
Baud Rate Value Baud Rate Value
255 28800 9 28800
254 14400 8 14400
N/A N/A 7
19200
253 9600 6 9600
250 4800 5 4800
244 2400 4 2400
232 1200 3 1200
208 600 2 600
160 300 1 300
N/A N/A 0 110
EASY-TUNE Enable ETE B008 0 he to a 1, th Y-TUN lgorithm
al
W n set e EAS E a is
implemented. This parameter is left at 0 for norm
instrument operation. (See
Section 11 .)
Display Brightness BRIGHT B012 4 n
value of Index
This parameter controls the display scree
intensity. A value of 0 is the brightest, and a
7 is the dimmest intensity. Normal viewing setting is
4.
ANI0 Calibrate Zero CIZ B263 s is the calibration zero adjustment. This
ed
Thi
parameter is factory set and should not ne
adjustment under normal operation. See
Section
12.3 for adjustment.
ANI1 Calibrate Zero CIZ B264 zero adjustment. This
ed
This is the calibration
parameter is factory set and should not ne
adjustment under normal operation. See
Section
12.3 for adjustment.
ANO1 Calibrate COZ B267
Zero
zero adjustment. This
ed
This is the calibration
parameter is factory set and should not ne
adjustment under normal operation. See
Section
12.3 for adjustment.
ANI0 Digital DFILT B269 3
- 102 s
Filter Index
This controls a first order filter that is applied
to the input signal. The time constant is
entered as an index value as follows:
t) 0 -No Smoothing (no effec
1 -0.05 s 6 - 3.1 s 11
2 - 0.1 s
3 - 0.3 s
4 - 0.7 s
5 - 1.5 s 7 - 6.3 s
8 -12.7 s
9 -25.5 s
10 -51.1 s
12 - 205 s
13 - 410 s
14 - 819 s
15 -1638 s
ANI1 Digital DFILT B270 3 his first o at is e
x
- 102 s
Filter Index
T controls a rder filter th applied to th
input signal. The time constant is entered as an inde
value as follows:
0 -No Smoothing (no effect)
1 -0.05 s 6 - 3.1 s 11
2 - 0.1 s
3 - 0.3 s
4 - 0.7 s
5 - 1.5 s 7 - 6.3 s
8 -12.7 s
9 -25.5 s
10 -51.1 s
12 - 205 s
13 - 410 s
14 - 819 s
15 -1638 s
Control Alarm
Mode
AIX B335 1
his r def rm A &
A2 nterpretation the two Alarm imits (PL1 &
PL2). It is entered into the datapoint as an index
value (0-6 ) as follows:
0 PA1n: high when PV> PL1
PA2n: low when PV< PL2
1 None
T
P paramete
) i ines the Ala
of
ctive (PA1
L