Liquid Controls SP3000 - Manual (Page 42)

42
8.2 PRINT LIST (RS-232 OPTION)
During normal operation, the instrument may be set up to print out, through the RS-232 port, the important
operating data such as flow rate, temperature, or pressure. The same data that is available for display can
be scanned and printed out the serial port of the instrument.
The operator can designate up to 16 items of this list that will be printed, and in which order they will be
printed. NOTE: Each item can be selected more than once in the print list even though there is no
advantage to doing this.
Use the same procedure and the same list to set up the list of items to print as used for setting up the
display list. (Refer to previous section 8-11)
(Select the item by pressing the key while the item is displayed.
For Example:
DISPLAY:
PRESS:
Select item #1
Flow Rate
Select item #2
Totalizer
Select item #3
Temperature
Select item #3
Pressure
Continue the process until a list of all the parameters to print while the instrument is running has been
established. Use the key to break out of the menu after the list is created. Make sure that the Print
Interval and the serial port have been activated in the Standby Menu for enabling this feature.
8.3
PRINT SYSTEM SETUP (RS-232 OPTION)
This feature is for use in documentation. When this menu item is selected, an entire print out of all the user
defined parameters is sent out the RS-232 port.
DISPLAY:
PRESS:
Running...
Show Data?
Running...
Go to Standby?
Continue Pressing until:
Running...
Print system setup?
A system dump of the parameters through the RS-232 serial communications port is performed.
ENT
A
ENT
ENT
ENT
C
A
A
A
ENT