Liquid Controls SP3000 - Manual (Page 2)

2
- W A R N I N G -
This instrument contains electronic components that are susceptible to damage by static electricity.
Please observe the following handling procedures during the removal, installation, or handling of the
internal circuit boards or devices.
HANDLING PROCEDURES
1.
Power to unit must be removed.
2.
Personnel must be grounded, via wrist strap or other safe, suitable means, before any printed
circuit board or other internal device is installed, removed, or adjusted.
3.
Printed circuit boards must be transported in a conductive bag or other conductive container.
Boards must not be removed from protective enclosure until the immediate time of installation.
Removed boards must be placed immediately in protective container for transport, storage, or
return to factory.
COMMENTS
This instrument is not unique in its content of EDS (electrostatic discharge) sensitive components. Most
modern electrical designs contain components that utilize metal oxide technology (NMOS, CMOS, etc.).
Experience has proven that even small amounts of static electricity can damage or destroy these devices.
Damaged components, even though they appear to function properly, exhibit early failure.
*** SPONSLER, INC. STRONLY RECOMMENDS THOROUGH UNDERSTANDING AND REVIEW OF
THIS MANUAL PRIOR TO INSTALLATION.