CONTREX MLP-Drive - Manual (Page 48)

3 - 10
Table 3-4 Default Master Scaling Control Parameters
CP Parameter Name Parameter Value
CP-34 Max RPM Feedback 2000
CP-31 PPR Feedback 60
CP-20 Master Engineering Units 2000
Table 3-5 Entering Master Scaling Control Parameters
CP Parameter Name Parameter Value
CP-34 Max RPM Feedback
CP-31 PPR Feedback
CP-20 Master Engineering Units
Enter the maximum desired RPMs,
measured at the sensor shaft.
Enter the number of gear teeth or
encoder lines on the sensor per one
revolution (pulses per revolution).
Enter the Master Engineering Units
value if the system were to operate at
the maximum desired RPMs entered in
CP-34.
Now that your scaling has been established, you can enter a value for Master
Setpoints 1 and 2. The value that you enter for a setpoint is the Engineering Units
(E.U.s) that you want to operate your system at.
The factory default Control Parameters for Master Setpoint 1 and 2 are set at “0”. To
modify these default parameters, refer to Table 3-6. You can toggle between the two
setpoints, if you have wired the Setpoint Select accordingly. Setpoint Select (located
at J5 pins 10, 13), determines which of the two setpoints is active.