CONTREX MLP-Drive - Manual (Page 156)

Glossary - 8
Output Monitoring Drive Output (MP-47)
Logic Outputs (MP-56)
Output Test Tests the Logic Outputs.
Outputs Drive Out
Dig_Out1
Dig_Out2
Parameters Parameters are divided into two classifications; Control
Parameters (CP) and Monitor Parameters (MP).
Parameter Code The numbered code that represents a Parameter.
Parameter Send Use the Parameter Send to change any of the MLP-Drive's
Control Parameters in Serial Communications.
Parameter Value Parameter values are pre-loaded in the factory, however,
you can modify Control Parameter values with operational
data that is unique to your system.
Performance Monitoring Tach
Deviation (Error)
Pulse Error Count
Scaled Reference
Ramped Reference
Trim Output
PROM Chip The PROM (Programmable Read Only Memory) chip is
the software for the MLP-Drive. This is not to be confused
with the EEPROM (which is were the default Control
Parameters and Monitor Parameters are stored).
PROM Test One of the two power up diagnostic routines that the
MLP-Drive automatically performs during every Power Up.