CONTREX MLP-Drive - Manual (Page 174)

C - 8
MP-50 ACTIVE SCALING MODE
Active Scaling Mode (MP-50) displays a number “1” to indicate the active scaling mode. In the
example below, “Master Mode” is the active scaling mode.
Direct Mode
Master Mode
Follower Mode/Offset Mode
Inverse
Code
MP-51 KEYPAD ERROR
If a Control Parameter entry has been rejected, Keypad Error (MP-51) will ascertain the reason
that it was rejected. The digit that displays a number “1” is the error. In the example below,
“Above Maximum Allowed Value” is the error.
Invalid Code Parameter
Above Maximum Allowed Value
Below Minimum Allowed Value
Entry Timeout or Keypad Lockout
Code