Clear-Com BS850 (Last time buy) - Manual (Page 29)

Status Displays
Status displays provide information indicating the status of the system, or of parts or functions of the system.
Transmitter Status:
Select transmitter 1 or 2, then press the ENTER
button to obtain the status of the selected
transmitter.
Receiver Status:
Select receiver 1 through 4, then press the
ENTER button to observe signal and tuning
levels for the selected receiver.
System Status:
Base station power supply voltages are shown.
The 12V box shows the actual input voltage
supplied to the base station. The T
°C box shows
base station internal temperature in degrees Celsius.
Beltpac Status:
Select a Beltpac by the name or number shown,
then press the ENTER button to obtain its status.
Select Stop Tlk to stop a latched-on Beltpac from
transmitting.
The Pwr box shows the current transmitter power
level of the selected Beltpac.
The Sig box indicates how well the Beltpac is
receiving transmission (Low, OK or High) from
the base station.
The Bat box shows battery status of the selected
Beltpac (OK, Low or Dead).
Talk Status:
Beltpac user identification is shown when Beltpac
user is pressing Talk button.
NOTE: In Push-To-Transmit (PTT) or Push-To-Enable
(PTE) modes, Beltpacs automatically update status to
the base station every 3 seconds. In Push-To-Share
(PTS) mode, Beltpacs only update status while they are
transmitting. If no transmission is received from a
Beltpac within 20 seconds, its status will be shown as
Unk (unknown). Also, if a Beltpac is out of range, or
its power is off, its status will be shown as Unk.
26