Clear-Com BS850 (Last time buy) - Manual (Page 28)

Headset Output Mixing (continued):
Select HSL (headset left) or HSR (headset right),
then select the box(es) next to Rx1-Rx4 to enable
input. Use the control knob to adjust output level in
0.25dB or 2.25dB increments for the desired mix.
Check these boxes only if you want receiver audio
continuously fed to the Headset Output. Leave
them unchecked for normal operation.
Place the cursor to the left of the bar below HS:dB
and use the control knob to adjust the overall
headset audio output level in 1.5dB increments.
Alert Settings:
To set the Alert relay to close under the desired
conditions select any or all of the boxes by
moving the cursor to a box and pressing the
ENTER button. If no boxes are checked, the alert
relay will not be used.
NOTE: Error indicates the base station detects
an error condition. Over Temp indicates the
internal base station temperature is excessive.
BP Low Battery indicates that any Beltpac in the
system has a low battery. BP Button indicates
any Beltpac button that has been programmed as
an alert button.
Page Settings:
To activate the page feature, select Enable and
press the ENTER button. When the PAGE
button on the beltpac is pressed, the audio is
routed only to the Page Connector on the back of
the base station. The user will not hear a sidetone
confirmation in their headset. Other beltpac users
will not hear the page in their headsets.
NOTE: If the page relay is not enabled and a
Beltpac page button is pushed, a reject tone will
be heard in the Beltpac’s headset.
Synchronize Base Station Settings:
To configure synchronized base station settings,
press the ENTER button.
NOTE: This only pertains to systems with
Master and Slave base stations. All Beltpac
settings are done in the Master base station.
Synchronizing the Slave bases will cause all
settings from the Master base station to be
transferred to the Slaves.
25