Burkert Type S020 - Manual (Page 8)

8
Description
Type S020
5. deScripTion
5.1. Area of application
The S020 fitting simplifies the installation of insertion devices for mea-
suring flow, pH, oxidation reduction potential (REDOX) or conductivity
on DN6 to DN400 pipes.
The fitting S020 is available in various versions for the installation of
measuring devices with a G2'' nut or measuring devices with a clamp
process connection.
The S020 measuring chamber is used:
• on the one hand, to install an insertion device for measuring the
pH, the oxidation reduction potential or the conductivity in a pipe
• and, on the other hand, to guarantee that the measurement sensor
is fully covered by the fluid.
6. TechnicAl dATA
6.1. conditions of use
Fluid
temperature depends on the device inserted and the material
from which the S020 fitting is made. Refer to the
operating instructions for the device and to the tem-
perature/fluid pressure dependency curve in Fig. 5.
If the ranges are different, use the most restrictive
range.
Ambient
temperature depends on the device inserted into the S020.
Refer to the related operating instructions.
Pressure
class depends on the device inserted and the material
from which the S020 fitting is made. Refer to the
operating instructions for the device and to the tem-
perature/fluid pressure dependency curve in Fig. 5.
If the pressure classes are different, take the lowest
value into account.
6.2. Available certificates
• Certificate 3.1, S020 in stainless steel only
• Certificate 2.2
• Surface roughness certificate
• Calibration certificate
• FDA approval (with EPDM seal), S020 in stainless steel only
English