Burkert Type 8644 - Manual (Page 92)

88 - 8644/phoenix
S
YSTEM
D
ESCRIPTION
Terminal errors
Type No. Cause of error Resolution
5 1 A fault has occurred in your peripheral
switching (e.g. short circuit of actuator
overload). On the basis of the PROFIBUS address
and the participant number it is possible to
ascertain the station and AirLine terminal
on which the peripheral fault has occurred.
The location of the error can be recognised
by the flashing LED on the AirLine terminal
or with the aid of the device-specific diag-
nosis in your control. On the basis of the
terminal datasheet, check which fault may
trigger this error message.
Remedy the fault in your peripherals.
2 Terminal not ready. Ascertain the precise location of the error
with the aid of the device-specific diagnosis
in your control.
Check the electrical connection.
Local bus errors in the station
Type No. Cause of error Resolution
4 1 An error has occurred in the local bus
signal (Data In). Ascertain the precise location of the error
locally on the basis of the LEDs or with the
aid of the device-specific diagnosis in your
control.
Check the connection between the
displayed participants.
2 An error has occurred in the local bus
signal (Data Out). Ascertain the precise location of the error
locally on the basis of the LEDs or with the
aid of the device-specific diagnosis in your
control.
Check the connection between the
displayed participants.
3 An error in the data transfer between
AirLine terminals has occurred.
The error could not be located. Check the configuration of the station.
4 The AirLine terminal is not ready. Ascertain the precise location of the error
with the aid of the device-specific diagnosis
in your control.
Check the electrical connection.
5 The replacement AirLine terminals does
not match in length or ID code.
Remove the terminal from the station.
Ascertain the precise location of the error
with the aid of the device-specific diagnosis
in your control.
6 An additional AirLine terminal has been
added. Check the configuration of the station.
If the configuration is correct, switch off the
power supply briefly so that the new
configuration is adopted.