Burkert Type 8644 - Manual (Page 14)

10 - 8644/phoenix
I
NSTALLATION
/ C
OMMISSIONING
Observing manufacturer’s instructions, snap all electrical modules / terminals to the left of the valve
block onto the standard rail.
Installation of the AirLINE system (e.g. in a control cabinet)
During work in the control cabinet, observe the relevant safety regulations!
Before mounting, check whether the mounting rail is properly anchored in the control
cabinet or in the system.
Observe the sequence of installation specified in the configuration file(s).
Observe the notes for the connected system!
ATTENTION!
Mount all other modules / terminals on the rail.
NOTE Alternative for large valve blocks:
- Remove the preceding module
- Snap the valve block onto the standard rail
- Slide the block to its final position
- Snap on the preceding module again
Slide the valve block onto the rail along the interface of the preceding module.
Screw the valve block to the rail by tightening the fixing screws clockwise.
ATTENTION!
The valve block is not securely fastened to the standard rail until the fixing screws have
been firmly tightened. Throughout the installation, you must ensure that it cannot fall.