Burkert Type 2301 - Manual (Page 43)

43
Replacement parts
12 replacemenT parTs
Warning!
risk of injury when opening the actuator!
The actuator contains a tensioned spring. If the actuator is
opened, there is a risk of injury from the spring jumping out!
▶ The actuator must not be opened.
Caution!
risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable replacement parts may cause
injuries and damage the device and the surrounding area.
▶ Use only original accessories and original replacement parts from
Bürkert.
12.1 replacement part sets
The following replacement part sets are available for the globe
control valve Type 2301:
• Control cone set consisting of
control cone, dowel pin, graphite seal and lubricant.
• Valve seat set consisting of
valve seat, O-ring (depending on the version), graphite seal and
lubricant.
• Sealing set for packing gland consisting of the individual parts
of the packing gland graphite seal and lubricant (the (modified)
socket wrench is not included in the sealing set).
• Spindle guide for packing gland consisting of
VA spindle guide, graphite seal and lubricant.
5
7
1 Graphite seal
2 Control cone
3 Dowel pin
4 Valve seat
5 Sealing set for
packing gland
SP10 / SP14
6 Sealing set for
packing gland
SP22
6
8
Control cone set
1
2
3
4
7 VA spindle guide
SP10 / SP14
8 VA spindle guide
SP22
Fig. 32: Replacement parts
When installing a valve seat with a modified orifice, the
identification number for the globe control valve changes.
english
Type 2301