Dynasonics MFX Series Insertion MagProbe Flow Meter - Manual (Page 35)

Rev. 01/11
-3.1- MFX
After installation of the MagProbe sensor and connection of
appropriate power supplies to the MFX, keypad configuration of the
instrument can be undertaken. All entries are saved in non-volatile
FLASH memory and will be retained in the event of power loss.
The DMFXD2 is configured through the keypad interface and the
DMFXD1 is configured through a software utility at the Dynasonics
factory.
The MFX contains a four-key tactile feedback keypad interface that
allows the user to view and change configuration parameters used
by the MFX operating system.
1. The MENU key is pressed from RUN mode to enter PROGRAM
mode. The MENU key is pressed in PROGRAM mode to exit
configuration parameters and menus. If changes to any
configuration parameters have been made, the user will be
prompted with a SAVE?YES when returning to RUN mode.
2. The ARROW keys are used to scroll through menus and
configuration parameters. The ARROW keys are also used to
adjust parameter numerical values.
PART 3 - KEYPAD CONFIGURATION
General
Keypad
Operation