Datamax-O'Neil S-Class User Guide - Manual (Page 70)

62 S-Class
Ticket Stock Requirements (continued)
Dimension Description
[3]
Minimum Maximum Layout
A Ticket Width 2.0 3.25
B Reflective Mark Width
[6]
.50 3.25
C Reflective Mark Length
[4]
.125 –
D Distance between Reflective Marks
[4]
1.0 –
E Ticket Length
[4]
1.0 –
F Quiet Zone Width
[5]
.40 3.25
A
B
F
E
C
D
3
Units of measure are given in inches, and all dimensions are referenced in the direction of ticket travel through the printer.
4
The maximum allowable length of the combined ticket and mark measurement cannot exceed 99.99 inches.
5
This is an area free of reflective printing (excluding the reflective marks) that runs the entire length of the ticket.
6
Standard Media Sensor: The center of this mark must fall between .235 and 3.03 inches from the ticket edge, while allowing an adequate Quiet
Zone within that area.
Print Side Media Sensor: The center of the mark must fall between .250 and .750 of an inch from the ticket edge, while allowing an adequate
Quiet Zone within that area.