Datamax-O'Neil S-Class User Guide - Manual (Page 33)

S-Class 25
3.5 Resetting the Printer
There are two different reset levels possible for the printer:
3.6.1 Warm Reset
To reset the printer and return to the on-line mode: Press the PAUSE
button to go off-line and then press the F1 + F3 Buttons simultaneously.
3.6.2 Factory Default Reset
To return the printer to default database settings (see the table below),
perform the following procedure.
 Turn the printer ‘Off’.
 Press and hold the PAUSE/F1, FEED/F2 and TEST/F3 Buttons
while turning ‘On’ the printer.
 After the Fault Indicator flashes (approximately 20 seconds), release
all three buttons.
For verification, a Configuration Ticket can be printed. The printout will
reflect default settings until new configuration data is sent to the printer.
Default Database Settings
Function ST/SV 3210 Values ST/SV 3306 Values
Memory Configuration:
1
Internal Module
Scalable Fonts 128
64
128
64
Character Set
(parser mode dependent): See Appendix B See Appendix B
Cutter Auto Detect Auto Detect
Parser Mode:
2
DTPL DTPL
Print Speed:
3
8 4
Slew Speed:
3
8 6
Backup Speed:
3
3 3
Stock ID 5 5
Print Width 1.89 inches (48 mm) 1.92 inches (49 mm)
1
Allocations are in 4KB units each and configurable only in DPL Parser Mode.
2
This setting may arrive pre-configured, to change the setting see Section 4.3.1.
3
Values given are in Inches Per Second.