Datamax-O'Neil S-Class User Guide - Manual (Page 30)

22 S-Class
3.4 Resident Formats
Several formats are stored in memory for useful setup, operational, and
diagnosis information. Load stock that is at least 2 inches (51 mm) wide
to capture all the data and patterns on these resident formats.
3.4.1 Configuration Ticket
The Configuration Ticket provides firmware, memory, and options
information (depending upon the model, equipment, and firmware this
information will vary). To print a Configuration Ticket:
 With stock loaded, turn the
printer ‘On’.
 Press the PAUSE button to enter
the off-line mode.
 Simultaneously press the F2 and
F3 Buttons.
VER: S3210 - 01.00C 04/25/06
BOOT ES-2562-01A
CODE ES-2564-01C
FPGA ES-2563-01A
FONT 83-2565-06A
256K FLASH MODULE B
SYSTEM FLASH SIZE____ 2 MBYTES
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 4096 KBYTES
SYSTEM RAM AVAIL__ 3146 KBYTES
CONFIGURATION
DTPL SERIAL PORT DETECTED
9600,8,N
REFL, CUTTER
PRINT SPEED 8.0 IPS
SLEW SPEED 8.0 IPS
BACK SPEED 3.0 IPS
STOCK ID 5
START OF PRINT 4.28 in
CUT/TEAR POSITION 4.26 in
ROW ADJUST 0.00 in
COLUMN ADJUST 0.00 in
VERTICAL ADJUST 11 dpi
PRESENT DELAY
COUNTER INFORMATION
ABSOLUTE VALUES 4-26-2006
LENGTH____ 350 INCHES
TIME______ 4 HOURS
RESETABLE VALUES 6- 5-2002
LENGTH____ 221 INCHES
TIME______ 2 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE A______ 128
SCALABLE FONTS_________ 64
LABEL SIZE 0189:23806 IN
INPUT VALUES
POT_________________ 195
REFL________________ 73
TEMP________________ 67
VOLT________________ 226
STOCK_______________ 40
PARSER MODE_________ DTPL
TOF LOW_____________ 0
TOF DELTA___________ 10
TOF GAIN____________ 6
NO REPRINT__________ NO
Counter/Memory sections include time
of operation and lengths printed, as well
as the printer’s memory configuration.
(Resettable Values can be useful in
tracking job data; see the DPL
Programmer’s Manual for details.
)
Input Values indicates the selected
parser mode and the printer’s internal
sensor values.
Configuration includes detected
communications (baud rate, the selected
communications port, detected parser
mode, etc.) as well as the speed settings,
Stock ID, and the start of print and
cut/tear positions.