Datamax-O'Neil S-Class User Guide - Manual (Page 41)

S-Class 33
4.1 Stock ID Selections
The printer maintains a selection of 10 user modifiable stock setups.
Each setup defaults to a specific print width, start print position and
cut/tear position, where:
 The Print Width is the print
distance across the ticket.
 The Start of Print Position is the
distance, measured in inches,
from the Media Sensor to
printhead burnline.
 The Cut/Tear Position is the
distance, measured in inches,
from the Media Sensor to the
cut (if equipped) or tear position
of the printed ticket.
The Stock ID can be set using the
Operational Database Modification
procedure (see Section 4.3.1). As
defined on the following page,
Stock ID numbers 0 through 8 are
not changeable through host
commands; however, Stock ID 9
will allow host commands to
override the default settings.
If none of the listed Stock ID
selections fit your media, select the
Stock ID that is closest to the
physical dimensions of your stock and then modify the Start of Print and
Cut/Tear positions (see Section 4.2). All changes can be saved to the
Stock ID, allowing commonly used formats to be recalled. To revert to
the default values, reset the printer (see Section 3.6).